Covers, clips, and guides
Recreate protective, locating, or retention components when the original plastic piece is damaged or no longer available.
Part recreation
Replacement Parts & Reverse Engineering for Plastic Components
Reference formsLayer study
Additive form studiesNot to scale
Start with the evidence you have: photos, approximate dimensions, a broken part, a physical sample, or an existing file. We will review whether the component can be recreated responsibly.
- 01
- A finished 3D model is not required
- 02
- Test fit before the final part or production quantity
- 03
- CAD revision can support later reorder requests
Capabilities
A practical path for unavailable plastic parts
The best candidates have geometry and use conditions that can be inspected and validated. Critical safety requirements or certifications change what can be accepted.
Brackets and adapters
Build around the measured interfaces, fasteners, clearances, and loads that matter to the installation.
Knobs and control components
Reproduce accessible non-safety-critical geometry, including bore, shaft interface, grip, and labeling constraints where practical.
Enclosures and discontinued components
Translate an existing housing or sample into a controlled CAD revision that can be tested, adjusted, and later re-quoted.
We do not accept weapons or weapon components, implants, safety-critical automotive parts, brake or steering components, or certified structural components without a separate formal agreement.
Workflow
From sample or photos to a tested replacement
Fit is verified before the final part or batch. The amount of measurement and CAD work depends on the geometry and the quality of the reference information.
- Step 01
Send the reference
Provide photos, dimensions, an existing file, or arrange review of the physical sample.
- Step 02
Evaluate the part
Review its function, interfaces, operating conditions, failure risk, and whether the project is acceptable.
- Step 03
Create and test CAD
Model the part, produce a test, and use fit feedback to create a controlled revision when needed.
- Step 04
Approve the final work
After fit confirmation, quote and produce the final part or reviewed quantity against the approved revision.
Related capabilities
Continue planning your part
Choose the path that best matches the information you have today. We can help connect design, prototyping, and production steps.
Start a project
Show us the part that needs to exist again
Photos and approximate dimensions are enough to start the review. If a physical sample is needed, we will coordinate that after the initial request.